How To Replace A Front Catalytic Converter On A 2006 Ford Taurus

Question: How To Replace A Front Catalytic Converter On A 2006 Ford Taurus,
We have a 2006 Ford Taurus, and we’re pretty sure the Front Catalytic Converter is the problem it’s hesitating, and shaking. I’m wondering how you would remove/replace the front catalytic converter. If you know of any videos, or anything like that. I’ve tried looking on the internet, with no luck. If anyone can help, it’d be appreciated.

Remember, it’s a 2006 model Ford Taurus.
Thank you in advanced.

Best answer for How To Replace A Front Catalytic Converter On A 2006 Ford Taurus

1. Install the code scanner to the OBS port under the Ford Taurus’ driver’s side dash. Turn the ignition key on, and the scanner will display the word “Read.” Press the button for “Read,” and the scanner will display the codes. Write the code or codes down and look for the corresponding explanation of the codes, which is displayed in the form of a number, in the chart provided with the scanner. If it states that sensor 1 or sensor 2 is not giving a proper signal, then the first one is before the converter and the second after the converter.
2. Correct the other codes first, then hit “Erase” on the scanner to clear the codes, and recheck with the engine running to see if the code comes back. If there were other codes, it is entirely possible that other issues caused the mixture to be wrong, causing the computer to set a code for the oxygen sensor. Oxygen sensors are not cheap and respond directly to the activity of the engine weather, good or bad, with a corresponding signal. If the oxygen sensor code still shows up, go to Step 3.
3. Raise and support the vehicle on jack stands. Disconnect the wiring harness at the pig tail for the sensor. Remove the oxygen sensor with the appropriate wrench or socket.
4. Brush anti-seize compound on the threads of the new sensor and tighten it in its socket on the vehicle. There is no need to crank down on the sensor; just make sure it is tight. Plug the electrical connector into the new oxygen sensor.
5. Turn the key on and hit the “Erase” button on the scanner; it will turn the “Check engine” light off on the dash and erase the code.

Answers for The Question

  1. Jeffery
  2. John Stooos
  3. Jamesgod
  4. Dennis
  5. Wroy Long
Incoming search terms: Sorry no terms yet